Wax Team Members are responsible for performing start of shift checks on the wax injection machine, monitoring and adding wax to the heater when it is low, setting up dies to be used for parts injection, reading travelers & setting pressures and temperature as indicated, helping to monitor and maintain the injection machine, and cleaning & organizing the work area.
Dip Operator are responsible for hand dipping parts twice, then loading and unloading parts into the producer for the automated dipping process. The Dip Operator also makes slurry for parts to be dipped, and performs start of shift checks and setup on all equipment.
Foundry Team Members are responsible for pouring molten steel into an investment cast molding using both manual and automatic pouring processes. Foundry Team Members also use equipment such as, but not limited to, Autoclave, Cut Off Saws, Cranes & Lifts, Media Blasting Material, Pulleys & Automated Processes.
Grind Operator Team Members are responsible for grinding the surfaces of the propeller in preparation for finishing. All grinding is performed by holding the propeller in hand and guiding the part across various grinding belts. The Grind Operator also reports any defects found in the surface after grinding is completed, performs start of shift checks, and sets up all equipment pertaining to the grinder position.
The Drag/Vibe Finish Team Member is responsible for loading and unloading propellers into the finishing equipment. The Drag/Vibe Finish Operator also fills finishers with media as needed, sets the program/timer on equipment, and performs setup & start of shift checks on all equipment pertaining to the vibe or drag finisher.